FETtec KISS G4 - N Flight Controller V1.7

Description

Now shipping V 1.7
New in 1.7:
Latest STM32G473 Processor - More powerful processor than V1.1
New Gyro:  IIM-42652 SPI
Improved IO Protection:  All IOs of microcontroller protected against voltage or current spikes
New Firmware:  (KISS FC Firmware Flashable)
The next generation of FETtec's popular KISS flight controller has arrived! Featuring the latest STM32 G4 MCU with math accelerator for the ultimate in flight performance, IIM-42652 gyro, 2 dedicated BECs for 5V and 16V switchable power, DSHOT2400 outputs for support of up to 8 motors, and dual 20x20 and 30x30 mounting holes.
This new "N" version simply means there is no onboard analog OSD chip.  Due to global shortages, the OSD chip was removed.  This only affects analog systems, there are no other restrictions and you can use the full potential of this FC as you are used to.  The use of external OSD boards and digital FPV systems still work fine.
The FETtec OSD Board is perfect for analog users still wanting OSD.
Comparison
:
Specifications
:
Latest STM32G4 Processor
180Mhz + Math accelerator
Gyro IIM-42652 SPI
Supply voltage 6-27V (2S-6S Lipo)
2x dedicated onboard BEC (2A each)
5V BEC for RX
5V/16V BEC for VTX (switchable and real Pit*)
Improved IO protection
All IOs of the microcontroller e.g. in connectors or solder pads are protected against voltage or current spikes
2x 8 pin connector for solder free ESC connection
Connector 1: ESC signal 1-4, telemetry, VCC, GND
Connector 2: ESC signal 5-8 (depending on UAV type 1-4), telemetry, VCC, GND
1x 8 pin connector for solder free VTX, cam connection and OSD or digital systems
real Pit* VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3
2x 6 pin connectors for serials
RX1, TX1, 3.3V, VCC, 5V, GND
RX3, VCS/TX3, RGB LED, VCC, 5V, GND
1x 4 pin connector for receiver
Signal, TLM, 5V, GND
5 UART serials
UART 1 free
UART 2 used for Receiver
UART 3 free
UART 4 free
UART 5 used for ESCs / TLM / Onewire
4 ESC solder pads (Signal/GND) in each corner
Buzzer pads
4 tiny RGB LEDs (selectable color)
Supported ESC protocols
PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
FETtec Alpha FC firmware (KISS FC firmware flashable)
Connector type: JST-SH-1mm
*real Pit-Mode: A power supply pin which is remotely switchable
Dimensions
:
Maximum outside dimensions: 37,2 x 37,2mm, without outside tips 30 x 30mm
Mounting hole arrangement:
20 x 20mm with M2 mounting hole (expandable to M3)
30 x 30mm with M3 mounting hole
30 x 30mm mounting hole tips are removable to reduce overall FC size
Overall height: 7,9mm
Weight: 5,37g
Includes
:
1x FETtec Flight Controller G4 - N V1.7
1x 8 pin cable
1x 6 pin cable
1x 4 pin cable